Month: March 2022

Tamiya Frog/Monster Beetle bottom chassis reinforcement pieces replacement (you will need to have two): upgradeparts-tami-frog-bottom-structure-pieces

Small lipo battery tray for Tamiya Frog/Monster Beetle The tray is for holding smaller lipo battery pack. It can be… read more Small lipo battery tray for Tamiya Frog/Monster Beetle

Special TT02 battery compartment partition block. This piece can be placed on the battery compartment side. It can be attached… read more Special TT02 battery compartment partition block

Front damper mount for Tamiya Grasshopper/Hornet. This mount allows the use of larger but shot dampers on these cars. It… read more Front damper mount for Tamiya Grasshopper/Hornet

Motor cooling fan mount for Tamiya Boomerang or similar models with the legacy MSC posts (via 2 screws): upgradeparts-tami-boomerang-motorcoolingfanmount

This is a very simple design – you use hot glue or tape to attach the mount to the side… read more Universal ESC cooling fan mount

Motor cooling fan mount for Tamiya Manta Ray/Blazing Star: The mount can be attached to the frame via hotglue or… read more Motor cooling fan mount for Tamiya Manta Ray/Blazing Star

One main cause that leads to a 3d printer not feeding filament properly is a jam due to material failing… read more Filament jam

7T motor pinion for toy grade RC car 380 motor (please use PETG – avoid PLA) upgradeparts-common-smallpinion7t-380motor Test run on… read more 7T motor pinion for toy grade RC car 380 motor

We recommend that you print using PETG (especially for parts that are constantly under stress). It is much stronger than… read more PETG vs PLA