Poor adhesion is a nightmare. Assuming your print bed has been properly leveled already, to improve adhesion there are two… read more 3D printing tech tip: better build plate adhesion

Caution: the use of water knifes requires extensive testing. You may need to customize the knifes so they work well… read more Experimental water knifes

This special modified rudder is designed to address steering issue commonly happened on boat with the rudder mechanism locating closer… read more Modified rudder for FT010/FT011

Turn fins for very small RC boats (overall boat length of 25cm or less): Overall length below 20mm: upgradeparts-turnfin-vsmall Between… read more Turn fins for small RC boats

This is a special adapter, allowing you to use a Nikko Dictator wheel on a regular hex adapter. upgradeparts-wheel-adapter-REVERSE-nikko-dictator

The overall dimension is 40mm, supporting 4mm shaft. upgradeparts-prop-40mm4mm   This is a variation of the 40mm prop: upgradeparts-prop-40mm4mm-v2  … read more RC boat props (experimental)

Turn fin mount for smaller boats: upgradeparts-turnfinmount-small Turn fin mount for larger boats: turnfinmountlarger      

If the heat block assembly or the nozzle is loose, one quick and easy way to help tightening things up… read more Techtip video: securing the nozzle

Tech tips for beginners We use polylactic acid PLA plastic filament for printing these models (the color of the material… read more General Tech Tips

A delta 3d printer has almost all the electronic stuff including the circuitry and the motors housed at the top…. read more Techtip video: Delta printer