3d printing techtip: Is support always required for overhang?
Is support required for large object with overhang? In this example, I accidentally forgot to…
0 Comments
Techtip: printing RC structural parts using PLA
When printing anything structural you should choose at least 50% fill, which will take hours…
0 Comments
RC Boat Cam Mount
This mount is designed to be attached to the spoiler (part of the top cover)…
0 Comments
EXPERIMENTAL Addon modified rudder for RC boat with steering issue
Warning: the concept is entirely experimental! This piece of addon can be attached to the…
0 Comments
3D printing tech tip: better build plate adhesion
Poor adhesion is a nightmare. Assuming your print bed has been properly leveled already, to…
0 Comments
Experimental water knifes
Caution: the use of water knifes requires extensive testing. You may need to customize the…
0 Comments
Modified rudder for FT010/FT011
This special modified rudder is designed to address steering issue commonly happened on boat with…
0 Comments
Turn fins for small RC boats
Turn fins for very small RC boats (overall boat length of 25cm or less): Overall…
0 Comments
Special Wheel Adapter for the vintage Nikko Dictator wheels
This is a special adapter, allowing you to use a Nikko Dictator wheel on a…
0 Comments
RC boat props (experimental)
The overall dimension is 40mm, supporting 4mm shaft. upgradeparts-prop-40mm4mm This is a variation of…
0 Comments